… in terms of progress.
I know I have writen “Be patient” on the lessons page, but that does not mean to be iddle. While I wait for the remaining parts to arrive (Neck pickup, pickguard and copper tape), I decided to solder and prepare as many components as possible. Also decided not to wire the components between them until I have the pickguard to mount them, in order to reduce the cable lenghts where it makes sense so the resulting guitar wiring does not look like an spaguetti bowl.
First the Fender 4P5T super switch was wired. Only outstanding connection into the switch are the neck and bridge pickups. The red and black cables on the left go to the volume pot and to ground on the back of the volume pot respectively. Not by best job but far from the worst
The volume potentiometer CTS 500K Linear. Too easy
Next was the blower switch. Red cable on the left of the picture goes to the tip in the output jack. The bridge pickup hot (black) is to be connected to the free connector.
Also decided to redo the jack connection because I want the guitar to be as quiet as posible (noise wise), so the jack connection is now a twisted pair. this is the only part that won’t be inside the main cavity which will be shielded with copper tape.
All the connections that I need to do next are:
- Neck and bridge pickup to the super switch and blower switch (Bridge).
- Neck “hot” from the switch to the switch,
- Connect the ground to the output jack
- Switch “hot” to and out of the volume to the blower switch.
- Connect the hot from the blower switch to the output jack